1. Mrdabbas's Avatar
    I changed the back housing... Everything works fine but the power button... It clicks great but no response!
    Please help I'm frustrated

    This is an iPhone 3G
    2011-01-06 11:34 PM
  2. Mrdabbas's Avatar
    Ok I opened it up and cleaned the flex cable and cleaned the power button.. It worked

    But now I have another problem.. There is a veeery slight gap between the bezel and housing that does not let me close the phone without pressing the screen and back together to close that gap.. How do I fix this... ?
    2011-01-07 12:40 AM
  3. Stray's Avatar
    Did you superglue it before placing it?
    2011-01-07 12:42 AM
  4. Mrdabbas's Avatar
    no.. Was I supposed to?
    And your talking about the bezel right?
    2011-01-07 12:50 AM
  5. dq13's Avatar
    most of the replacement cases will leave a gap. almost everybody sugest super glue, but make sure you are very careful not to spill ANY on the housing (on the outside visible area) as it will mess up the shiny look
    2011-01-07 02:00 AM
  6. Mrdabbas's Avatar
    Thx doood I'll give it a try and post back
    2011-01-07 02:26 AM
  7. Mrdabbas's Avatar
    Looks like new
    Attached Thumbnails iPhone power button does not work-imageuploadedbymodmyi.jpg  
    2011-01-28 03:35 AM
  8. StealthBravo's Avatar
    Sure does
    2011-01-28 04:01 AM
  9. Simon's Avatar
    2011-01-28 04:13 AM
  10. StealthBravo's Avatar
    Sexy
    2011-01-28 04:20 AM
  11. Mrdabbas's Avatar
    Thx guyz couldn't do it without u
    2011-01-28 04:47 AM
LINK TO POST COPIED TO CLIPBOARD