1. afgomar07's Avatar
    Hey thanks for checking out my post.. I had a quick question

    The bezel is seperated from the back housing on the right side of the iphone and the upper are around the sleep button. The sleep button doesnt work. Is that because the housing is seperated or what?

    When i push the bezel and housing it still does not work.

    Any suggestions would be appreciated. I also added a pic so you can see

    Thanks
    Attached Thumbnails Iphone 3g sleep button-imageuploadedbymodmyi.jpg  
    2011-03-15 07:24 AM
  2. harmon's Avatar
    the sleep button is supported by the bezel. So that separation could cause the button to malfunction.

    I would open it up and take a look at it from the inside.
    Lots of tutorials online for it..
    2011-03-15 07:53 AM
  3. afgomar07's Avatar
    Alright thanks bro ill do that
    2011-03-15 08:20 AM
  4. PotterFan's Avatar
    Also, check to see if there is anything blocking the front frame and bezel from going down all of the way. A lot of times, the camera is not placed properly, causing the phone to not be even near the sleep button. It's also possible, and I would try it, to hold the top right where it is protruding and attempt to press the button then. It should make a good conection and you should be able to properly push the button. Also consider getting a case to close the connection.
    2011-03-17 02:06 AM
LINK TO POST COPIED TO CLIPBOARD
We have updated our Privacy Policy and Terms & Conditions. Please check them out.