1. jkfox121's Avatar
    I recently installed SysInfo on my 1.1.2 jailbroken phone. Everyfeature seamed to be working perfect up until I hit the "Respring" buttom. It seamed as though it was about to respring and then it froze the phone.

    I did a soft reset, but the phone was stuck at the Apple screen. I couldn't get it to boot from recovery mode using the new jailbreak software or ibrickr.

    I had to restore to 1.1.1 and redo the whole upgrade/jailbreak/unlock process.

    Has anyone else had this problem? Suggest caution on 1.1.2 using SysInfo.

    Anyone else have this problem?
    Last edited by jkfox121; 2007-12-03 at 04:45 AM. Reason: Automerged Doublepost
    iPhone 3GS - 32GB
    2007-12-03 04:45 AM
  2. gamezz's Avatar
    wat exactly does the respring button do?
    2007-12-03 05:09 AM
  3. jkfox121's Avatar
    It resets/reloads the springboard, just like when you finish installing an application through "Installer" and it resets to the "slide to unlock" screen.
    iPhone 3GS - 32GB
    2007-12-03 05:04 PM
  4. NetMage's Avatar
    Works fine on my 1.1.2 - I think you must have had something else break it before you restart SpringBoard.
    2007-12-05 07:44 AM
LINK TO POST COPIED TO CLIPBOARD